SCSI Driver and firmware test V1.80
? 2014-2023 Uwe Seimet

SCSI initiator ID is not available

Found SCSI Driver version 1.01


Available buses:
  ID: 0
  Name: 'Atari ACSI'
  Maximum transfer length: 65536 ($10000)
  Supported SCSI Driver features:
    -


Testing device ID 0 on bus 0 'Atari ACSI'
  Supported SCSI Driver features:
    -
  CheckDev()
    Testing with valid bus ID 0
    Testing with invalid bus ID 32
  Open/Close()
    Available handles for bus 0: 31
  TEST UNIT READY
  INQUIRY
    Calling with valid data
      Device type: Direct Access
      Removable media support: No
      Device name: 'steem'
      Firmware revision: ''
      SCSI/SPC version: -
      Response data format: SCSI-1
      Additional length: $00
      ERROR: Additional length must be at least $1F
    Calling with non-existing LUN 7
      ERROR: Request was not correctly rejected
        Expected: Peripheral Qualifier $03  (got $00), Device Type $1F (got $00)
    Testing with requested byte count of 10
    ERROR: More than 10 requested bytes were returned
  REQUEST SENSE
    Calling REQUEST SENSE for existing LUN 0
      Additional sense length: $00
      ERROR: Additional sense length must be at least $0A
    Calling REQUEST SENSE for non-existing LUN 7
      ERROR: Request was not correctly rejected
        Expected: Sense Key $05 (got $00), ASC $25 (got $73)
    Calling REQUEST SENSE again for existing LUN 0
  READ
    Reading block 0 with READ (6)
    Reading block 0 to odd address with READ (6)
    Trying to read block 0 from non-existing LUN 7
      ERROR: Request was not correctly rejected
        Expected: Sense Key $05 (got $00), ASC $25 (got $00)
  SEEK
    Seeking block 0 with SEEK (6)
  MODE SENSE
    Reading all mode pages with MODE SENSE (6)
      Received 0 data bytes